Cisco Packet Tracer配置静态VLAN的步骤

2. 1：VLAN数据库配置模式创建VLAN：                                                                                       Switch#vlan database   进入数据库模 式                                                                                     Switch(vlan)#vlan       2nameT1             //添加VLAN2，并命名为T1，如果不指定VLAN名称，交换机自动使用默认VLAN0002

      Switch(vlan)#exit      //退出，保存             

   

3. 
   

4. 2

   2： 全局配置模式创建 VLAN：                                                                                                         Switch(config)#vlan 2                                                                                                                   Switch(config-vlan)#name T2

   
5. 3

   3：将端口加入VLAN：

   Switch(config)# interface interface-id                                                                                              //inter f0/1  进入要配置 的端口

   Switch(config-if)# switchport mode access                          

   //sw mode acc  定义二层端口模式

   Switch(config-if)#switchport access vlan vlan-id                           

   //sw acc vlan 2  将端口添加到VLAN2中

   

   
   

6. 4：也可同时将多个端口加入VLAN：

   Switch(config)# interface range f0/1  –10

                               //inter rang f0/1 -10  选择端口1-10                                                                       Switch(config-if-range)# switchport access vlan vlan-id

                               //sw acc valn 2 将端口1-10添加到vlan2Switch(config-if)# switchport mode access

   

   
7. 5

   5：查看：show vlan brief

   Switch(config-if)# no switchport access vlan vlan-id                             

   //no sw acc vlan 2 将其从vlan2里面删除

   Switch(config)# default interface interface-id

                                //还原接口为默认配置状态